Mig & Tig Welder at Motus Aftermarket Parts

• The purpose of the job is for Tig & Mig welding of Canopy kit components & Canopy Kits

Qualifications and Education Requirements

• At least 2-years’ experience in Mig & Tig welding both stainless steel and aluminum
• Red seal certificate in welding or minimum 2 years’ experience as per point 1 above
• Grade 12
• Ability to read, understand and interpret technical drawings.

Preferred Skills & Traits

• Honesty
• Focused and detail oriented.
• Meticulous and accurate.
• Good Communication Skills.
• Physically fit and strong
• Technically oriented

Key performance indicators

• Follow standard operating / welding procedure
• Setup welding machine for optimal welding on material & components to be welded
• Conducting Pre & Post welding inspections and recording critical dimensions
• Low non-conformance rate on welding
• Overall low scrap ratio
• Report any non-conformance or scrap part to department head immediately
• Maintain company standard on all welding.
• Maintain production targets and minimum requirements daily.
• Maintain welding equipment, tools, gauges, measuring equipment and machinery in clean and good working condition.
• General housekeeping at workstation
• Timeous Completing of all relevant production documentation
• Updating Rhinoman production system in real time
• Comply to Health & safety code

Role and Responsibilities

• Read & interpret technical drawings.
• Material identification.
• Jigging & fabrication
• Preliminary visual inspection of parts to be welded for visible damages. Scratches, dents, cutting defects faulty bending (not bend according to notches).
• Pre weld inspection: recording of critical dimensions acc to drw, measuring and recording of physical critical dimensions, Gauging parts with checking gauges for conformance.
• Reporting of any non-conformances before commencing with welding. HOD to sign off
• Correct setup of welding machine, welding gas , gauges and clamps.
• Welding of canopy kit components according to drawing dimensions and welding sequence.
• Welding of pre-assembled canopy kits according to drawing and critical dimensions.
• Reaching / exceeding minimum welding requirements in terms of quantity & quality daily. (Minimum requirements for a 9 hour work shift are as follows per component: Ribs x 7 sets; Doors x 14 sets; D/C canopies x 4.5 complete units; S/C canopies X 2.75)
• Post welding inspection: Measuring & Recording of critical dimensions after welding for conformance to drawing and signing of on quality on production paperwork.
• Every employee in the production line is responsible for quality and thus all and any deviations need to be reported.
• All welding to be done to company acceptable quality standards. Welding will be subjected to internal quality assurance. All non con-conforming welds will receive priority and be repaired by original welder immediately.
• All production documentation to be completed daily in real time.
• Always maintain welding machine, all tools, gauges and measuring equipment in good working condition.
• Perform tasks as requested from time to time by management or direct superior
• Comply with all health & Safety regulations and other company policy & procedures.
• General House Keeping in your workstation / welding bay and immediate surrounding area.

Closing Date 09 June 2023